![]() Such test allows to check narrow band frequency stability and measure Tx-Rx offset in low Hz range without any Test equipment!. Question: is it possible to program a separate independant connection interface to use a virtual audio cable. I can activate VB-cable only as autio output from SDR console (instead of loudspeaker or Headphone) and use volume control to adjust level, but loose my loudspeaker/Headphone then. Tried to activate VB-cable (in Skimmer setup) - but no success - unable to route that virtual audio cable to WSJT. Simon Brown, G4ELI -Original Message- From: On Behalf Of Charly DF5VAE Sent: 23 March 2020 11:46 To: Subject: option to connect 2nd virtual cable to SDR consiole Hello, May be I have not found an already existing option to route audio in SDR console to an external prg (other than CW skimmer) via a virtual audio cable. I plan a small interface window where you can assign VACs to RXs. On Tue, at 08:21 AM, Simon Brown wrote: Hi, I have been asked for this - I know how to add it, I'll probably add this once 3.1 is released but may add as part of 3.0.23, I plan to release 3.0.22 later this week. With not more than 100mW uplink power (in shack) and 15m coax to Poty feed I manage solid FT8 copy in downlink (with 12Hz offset) Amazing stability (using SV1AVN GPSDO) and beacon lock in SDR console. May be I have not found an already existing option to route audio in SDR console to an external prg (other than CW skimmer) via a virtual audio cable. ![]() To: option to connect 2nd virtual cable to SDR consiole ![]()
0 Comments
Leave a Reply. |